Easy Weigh LS-100 Bedienerhandbuch PDF herunterladen (Seite 6)

Preparation of the door

The following holes must exist in the door corresponding to the drawing:

1. Punched hole, dimensions 19.1 mm / 16 mm. A round hole with a diameter of 19.1 mm can also be

drilled at this position.

2. Round hole with a diameter of 7 mm.

As soon as the ﬁrst hole exists, as described in 1, the 7 mm round hole can be drilled by using a drilling tem-

plate (e.g. the drilling template at the end of the manual).

Installation

1. Insert the lock (1) into the two holes 19.1 mm / 16 mm and 7 mm

2. Fasten the lock (1) using the nut (2)

3. Screw on the lock (1) using the screw (8) and the bushing (6 or 7) depending on the thickness of the door

4. Fasten the grommet (3) for setting the rotational direction and the locking cam (4) using the bolt (5)

5. Test the lock function by means of the TestCode when the door is open

6. Test the function when the door is closed

Replacement of the rotary knob (as needed)

1. Remove the bolt (5).

2. Use a TG 10 screwdriver to loosen the fastening screw for the rotary knob by

inserting through the threaded hole for the bolt (5).

3. Fasten the new rotary knob in reversed order.

Installation Information

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Keine Kommentare

Easy Weigh LS-100 Bedienerhandbuch Seite 6