Easy Weigh LS-100 Bedienerhandbuch PDF herunterladen (Seite 10)

Operation

Operation is supported by the red/green LED display and an acoustic acknowledgement by means of signal

transmitters.

The key can be used to abort an input procedure.

The procedure is aborted automatically if there is a stop of more than three seconds between operating the

individual keys.

You have four attempts to enter the correct code. After the fourth incorrect entry the entry process is disabled

for one minute as protection against manipulation. The lock is blocked after 100 incorrect entries. Blocking

can only be released with MasterCode2.

All locks in the SAFE-O-TRONIC® LS 100 series are delivered with the same factory setting. The TestCode

for locking and opening is activated in the factory setting.

TestCode

The TestCode can be used to carry out a simple SAFE-O- TRONIC® LS 100 functionality check.

Locking and opening using the TestCode

 Press the 0 key

 Afterwards press the OK key

 Turn the knob

Notice: The TestCode is retained until initial operation.

General Information

Function control

√

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Keine Kommentare

Easy Weigh LS-100 Bedienerhandbuch Seite 10